telnet
Enables Telnet. Telnet provides a
command line interface to a remote host over TCP. Telnet provides no encryption, but it
does provide a measure of authentication. Telnet access is disabled by default.By
default Telnet, when enabled, uses Transmission Control Protocol (TCP) port
23. Use this command to change the TCP port.
Supported on the following devices:
- Access Points:
AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632,
AP7662, AP8163, AP8533.
- Service Platforms:
NX5500, NX7500, NX9500, NX9600
- Virtual Platforms: CX9000, VX9000
Syntax
telnet {port <1-65535>}
Parameters
telnet {port <1-65535>}
| telnet |
Enables Telnet |
| port <1-65535> |
Optional. Configures the Telnet port. This is the port used for Telnet
connections.
- <1-65535> – Sets
a value from 1 - 165535. The default port is 23.
|
Examples
nx9500-6C8809(config-management-policy-test)#telnet port 200
nx9500-6C8809(config-management-policy-test)#show context
management-policy test
telnet port 200
no http server
https server
ftp username superuser password 1 626b4033263d6d2ae4e79c48cdfcccb60fd4c77a8da9e365060597a6d6570ec2 rootdir dir
ssh port 162
snmp-server community snmp1 ro
snmp-server user snmpmanager v3 encrypted des auth md5 0 test123
snmp-server host 172.16.10.23 v3 162
aaa-login radius external
aaa-login radius policy test
idle-session-timeout 0
restrict-access host 172.16.10.2 log all
nx9500-6C8809(config-management-policy-test)#
